Just got done running the Teryx in the dunes all weekend. And towards the end of our trip the unit would not start when put in Neutral. If I turn the key I get nothing almost like it is still in gear. So now I need to push the brake pedal down to start every time. Is this a linkage adjustment issue - or should I take it in to Kawi for service...

__________________
2008 Teryx
So Cal Fab +5 Arms w/ Sway-A-Ways, Summers Brothers Axles, So Cal Fab 4 place Cage with roof, Beadlock Spec. Spyders with 9" BigHorns, PRP Low Backs w/ Crow Belts, Optimum Battery, Lawrence 540c Baja GPS, CDI by VDI, Radiator Shrouds, Billet Tip on Pipe, Wink Mirror, Billet Grab handels, 4 H.I.Ds across the top on So Cal Fab folding Light Bar, Trail Tech Vapor Digi Dash, Front & Rear Bumpers, SafeGlow LED whip, Momo Trek Wheel, 3/4 doors.

It sounds like a linkage adjustment. you can move the shift lever while trying to start it (with the brake off) to see where it needs to be adjusted too. It will turn over when the tranny is in the the right place then just adjust the linkage for it. I had to adjust mine a little bit.

I have also had to adjust mine

__________________
http://www.powellperformancefab.com

Hey thanks fro the info.. Just went out and slowly moved the shifter towards "H" and low and behold just about in the middle of "N' and "H" it started right up... Thanks again...

__________________
2008 Teryx
So Cal Fab +5 Arms w/ Sway-A-Ways, Summers Brothers Axles, So Cal Fab 4 place Cage with roof, Beadlock Spec. Spyders with 9" BigHorns, PRP Low Backs w/ Crow Belts, Optimum Battery, Lawrence 540c Baja GPS, CDI by VDI, Radiator Shrouds, Billet Tip on Pipe, Wink Mirror, Billet Grab handels, 4 H.I.Ds across the top on So Cal Fab folding Light Bar, Trail Tech Vapor Digi Dash, Front & Rear Bumpers, SafeGlow LED whip, Momo Trek Wheel, 3/4 doors.