Currently it appears that you browsing the forums as a guest, which means you will be limited on searching, viewing, downloading and participating! By Joining our FREE forums today you will receive discounts from our official vendors, updates about rides and events in your area, and access to upload your own photos.
Remember, we are the leading Teryx Enthusiasts forum on the web, with more users than any other site. Join now, and start posting in our New Members section today!
I installed a Gibson on my Teryx and found a problem. There are 2 rods on top of the stock exaust that go through 2 tubes under the bed and get a retainer clip in each to prevent the exaust from sliding off. The rods on the Gibson are about 1/2" to short and dont extend completely trough the tubes so that the retainers can be re-installed. Here are some pics before and after modification. I welded on 3/4" extensions to the rods, drilled new holes for the retainer clips and it worked out fine. Has anybody else had this problem?
Had same problem, but push the mid pipe that comes with the exaust a little bit more with bit of oil then soft hits the exhaust end with rubber hammer, and the holes just comes out.
RhinoForums.net, RZRforums.net, TeryxForums.net, RedlineUTVforums.net and BrianSquared LLC are in no way affiliated with or endorsed by the Yamaha Motor Company, Polaris Industries, Kawasaki Motor Corporation or Redline Performance Products. We are not a direct Yamaha, Kawasaki, Polaris, Redline Dealer or Distributor.
Gibson exaust problems
Linear Mode
