|
|
This is a discussion on problem with engine sputtering any ideas?? within the General Teryx Discussion forums, part of the Kawsaki Teryx Forum General Teryx category; just got machine back from engine rebuild and at 30mph and up it will occasionally sputter like someone turned the choke on for a second? ...
|
|||||||
| Home | Forum | Active Topics | Photo Gallery | Register | FAQ | Social Groups | Search | Today's Posts | Mark Forums Read |
| General Teryx Discussion For General Teryx talk. If it's about Teryx's and does not fall into another category, it belongs here! |
 |
|
|
LinkBack | Thread Tools | Display Modes |
08-24-2011, 06:27 AM
|
|||
|
|||
|
problem with engine sputtering any ideas??
just got machine back from engine rebuild and at 30mph and up it will occasionally sputter like someone turned the choke on for a second? already replaced fuel filter, fuel pump and drained gas and replaced with all new and dry gas any ideas what could be causing it to do this? could it be a air leak somewhere from something not being tightened properly or maybe carb problem ( it is a carburation model 08 ) thanks for any and all ideas!!!
|
| Sponsored Links | ||
|
TeryxForums.net is the premier Kawasaki Teryx Forum on the internet. Registered Users do not see these ads. Please Register - It's Free! |
|
08-24-2011, 07:41 AM
|
||||
|
||||
|
Slide in carb loosing vacuum?
__________________
All AMSOIL Fluids, LSR +5 XTR Suspension (Elka Elites), Rigid RAD4 Cage; Dually & 10" Amber, BS Sand Seats, Rigid HID, Lots of UTV Inc,, Dynatec CDI, Hunterworks Carb Kit, DJ Safety Belts, Fuel Gauge, Quick Light 6" Fiber Whip (red), Rugged Intercom, Monster Edition Rims, Maxxis Cerros, Lowrance HDS-5, DFR Steering Rack & Yoshimura Exhaust, Heads ported/polish by Action Powersports in Chandler,AZ az_amsoil@cox.net
|
|
08-24-2011, 03:26 PM
|
||||
|
||||
|
As you rev the motor a vacuum is created on the backside of the carb slide...this pulls the slide open (and the needle out of the main jet). If you have a hole or the seal around the diaphram isn't good, this vacuum will release and cause the slide to choke off the main jet fuel.
You don't see it at idle or up to around 1/4 throttle as the pilot jet is providing the fuel to the carb and the slide is closed. Make sense?
__________________
All AMSOIL Fluids, LSR +5 XTR Suspension (Elka Elites), Rigid RAD4 Cage; Dually & 10" Amber, BS Sand Seats, Rigid HID, Lots of UTV Inc,, Dynatec CDI, Hunterworks Carb Kit, DJ Safety Belts, Fuel Gauge, Quick Light 6" Fiber Whip (red), Rugged Intercom, Monster Edition Rims, Maxxis Cerros, Lowrance HDS-5, DFR Steering Rack & Yoshimura Exhaust, Heads ported/polish by Action Powersports in Chandler,AZ az_amsoil@cox.net
|
|
08-24-2011, 03:34 PM
|
||||
|
||||
|
Very well put AZ!
|
|
04-21-2012, 10:49 AM
|
|||
|
|||
|
I was just gonna post a new thread similar to this. If I'm cruising at around 3/4 throttle its fine. But..... If I'm cruising at 3/4 and then mash it to the floor it falls on its face and spit and sputters until I back off again. New fuel filter, oil, and clean air filter. Don't know where to go from here. Any chance its the rev limiter? I doubt it but don't know how the limiters react on these since I haven't had the experience?
Brent if I were u I would be calling the engine builder and let him figure it out. If he just rebuilt it i would thing it should run flawless when u get it home. Last edited by nitroburner13; 04-21-2012 at 10:52 AM. Reason: Automerged Doublepost
|
|
Lower Navigation
|
||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Search tags for this page |
2009 kawasaki teryx sputtering,kawasaki engine sputtering,kawasaki teryx engine rebuild,kawasaki teryx sputter,rebuilt engine sputtering,teryx engine rebuild,teryx engine sputtering,teryx is sputtering,teryx motor sputtering,teryx sputter,teryx sputtering
Click on a term to search our sites for related topics.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
