Kawasaki Teryx Forum banner

Fire extinguisher.

3K views 3 replies 3 participants last post by  Cheda 
#1 ·
I got the tusk fire extinguisher mount from Rocky Mountain. A two pack of extinguishers from home Depot (5$ more than a single from RM, same model) and mounted one up. Pretty happy with results I think I'll buy another mount and do two off center. Had to shim mount with some Teflon to silence rattles. One pin frees extinguisher and it's reached from any seat.
 

Attachments

See less See more
3
#4 ·
Done and done. That's an excellent point, when I got the mount the other pin/screw was barely finger tight I did put some locktite on it and screwed it down tight. I then realized I had overtightened it when the male piece of the mount wouldn't slide in so I had to take it back out. This wasn't fun as I had to use a horizontal screw driver without much leverage on the top side after the locktite had started to set up.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top