I just got my reflashed ecu back to today i installed it but now she will not fire up, it is refashed for muzzys but they have not shown up yet, is that why it wont start because of the stock exhaust?

I gotta imagine it should still start and run ok... Idk... Check all your connections and such...

__________________
09 Sport, Muzzy Pros, MSD, Dasa Intake, Dasa Impeller, Dasa OD Clutch Cap, Dasa Guage Pod, Black Rhino Guages, Painless Fuse Block, K2 Concepts Carbon Fiber, K2 Concepts Bed Delete, Four seat cage, Crow 5 Points, Neri Style Rear Seat, PRP Front Seats, Induced Fabrication doors, Billet King Steering Rack, Billet King Master Cylinder Guard, HID Conversion Kit, Baja Designs 6"Pre Runner HID's, HCR +6LT Kit, Fox 2.0 Shocks, G-Force Trilobite Tires, Scat Track tires, Sand Star Tires, Douglas Diablo Wheels, Full Fiber Skinz Skid Plates and way too much money!

Josh, I had to give mine alittle gas on the peddle to get her to start and had to run it alittle so the ecu could adjust and the teryx4 would then idle. Hope that helps


Danny

turn the key off and on 2 or 3 times to reset the idle circut it should run fine you may hold it to the floor that could help dont pump on hold down on the throttle

yeah it's hard to start at first and it'll run like crap for a few minutes. then after all that, it'll start just like stock and run like a rapped ape.

__________________

11' Benchmark Performance XP9


12' T4

Thanks guys ill give it another shot in the morning now that i know its common i feel better because i was freakin out earlier

It will take a little bit to self learn. Give it a little gas to start it up and you will find it will start but run poorly. Let it warm up and run it for a bit, it will self learn and the next time you start it up it will start easy and run great.

Ok i tryed half throtle and full nothing so i removed the spark plug put it back in the wire and get no fire at all

make sure ur ecu is plugged in correctly, if still nothing then call Chris tomorrow.

__________________

11' Benchmark Performance XP9


12' T4

Ok i unhooked the battery thinking maybe that would reset everything, dont know if it did but when i hooked the battery back up and checked for fire it cranked up on one cylinder put the plug back in and now shes back, let it run for about 10 min shut it off and cranked right back up

Thanks guys