Recently purchased a 2019 Teryx Le. Ordered a 6” lift kit from super atv. We also ordered new 32” intimidator tires. It says that if you use factory wheels you must use a 1” spacer. But not if you have aftermarket wheels. I know the factory wheels have an offset of 4+3. Therefore you need the inside to be a 3 on the offset otherwise the tires will rub? If that’s the case then there are so many after market wheels with the same offset so you will have same problem on an after market wheel with an offset of 4+3. Correct? Called in to SuperATV and left call back number but haven’t heard from them yet so thought maybe someone of this forum would know. Our issue is the lift kit also makes you 3” wider per side. So starting at 61” wide and adding the 6” makes us 67. Some of the places we ride you cannot get through if your over 69. If we use spacers on tires (we bought 1 1/2 instead of 1 because SuperATV was out at the time) 67 adding the spacers takes us to 70 and that’s without the tire. Only other option is an aftermarket tire with no spacers to get out width down if possible. Would a wheel with a 2+5 offset work with this setup?
Pretty sure an aftermarket 4+3 wheel will place the tires out a little further than the factory wheels....I don't even believe that either the front or rear factory wheels are 4+3 because they are not 7" wide.