Kawasaki Teryx Forum banner

1 - 2 of 2 Posts

·
Registered
2018 teryx 4 le
Joined
·
26 Posts
Discussion Starter #1 (Edited)
2018 t4 le model started chop tonight. I cut 1 3/4 front 4 inch in back and now I'm on break will cut center tomorrow and weld up cage!! So far so good. I got 2 inch stainless steel tube cut four 3 inch pieces cut 1/4 out to fold into roll cage as insert!! Am going to mig it with Lincoln 170 flux...ok now complete ending up doing 4 inch rear 1 3/4 front 2 3/4 middle bar...advice cut upper part on 4 corners then cut urnlower section so it dosent shake on you. Made that mistake 1x..turned out well im 5'11 in rear now I have 5 inch clearance front about 4.5 so close!!!!!! Kinda duck to get in front now or.hit top rail
63090
63091
63092
 

Attachments

1 - 2 of 2 Posts
Top