Kawasaki Teryx Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
I installed a Gibson on my Teryx and found a problem. There are 2 rods on top of the stock exaust that go through 2 tubes under the bed and get a retainer clip in each to prevent the exaust from sliding off. The rods on the Gibson are about 1/2" to short and dont extend completely trough the tubes so that the retainers can be re-installed. Here are some pics before and after modification. I welded on 3/4" extensions to the rods, drilled new holes for the retainer clips and it worked out fine. Has anybody else had this problem?
 

Attachments

·
Registered
Joined
·
2 Posts
Had same problem, but push the mid pipe that comes with the exaust a little bit more with bit of oil then soft hits the exhaust end with rubber hammer, and the holes just comes out.
 
1 - 2 of 2 Posts
Top