Kawasaki Teryx Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I' am currently in the process of installing a Dalton Clutch kit. I got the primary off and the new Dalton parts installed no problem, though when I went to get the secondary off, it will not even begin to slide off the shaft. I have soaked it with Penetrating oil, WD-40, used a rubber mallet, pry bars, and even tried hooking a come along up to it to pull it off...with no luck.

Anyone experienced this issue before and have any tips on how to get this damn thing off?
 

·
Registered
Joined
·
1,064 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
I don't believe it has ever been off. I bought it used, so hard saying. It's a 2010, with about 1000mi.
 

·
Registered
Joined
·
1,064 Posts
Yeah it's probably on there good. There are some tips in those threads, maybe one will help.


Try Tapatalk!!
 

·
Registered
Joined
·
216 Posts
mine was the same way, lucky I had my motor out at the time. It was so hard to get off the shaft,finally after a couple of days of soaking and beating,prying it came lose. good luck
 
1 - 5 of 5 Posts
Top