Stator or...?

972 Views 4 Replies 3 Participants Last post by CCC, 7 mo ago

SageCrispin

Discussion Starter · 9 mo ago

2014 Teryx4 3635 miles 667 hours

I know I'm grasping at straws here, but I just hope this is somehow not as bad as it sounds.

1. The photo shows the 3 wires from the stator, correct? (The two separate connectors make me question it.)
2. They have continuity between them and no shorts to ground.
3. I have 2.5 and 4 volts AC with running engine, depending on the combination of leads. The voltages are steady at all engine speeds.
4. Now what?

Electrical wiring Cable Gas Fixture Auto part

See less See more

Save

1 - 1 of 5 Posts

brokennosescotty

· #2 · 9 mo ago

I do not have a 2nd Gen. manual in front of me, I believe there is a digital copy on this site? My 2011 manual says you should see 52 to 78 volts AC between ant two of the output leads at 4,000 rpms. A 2014 should be similar, your readings seem very low. Loss of magnetism in the rotor can also cause low output.

Mike

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month