Kawasaki Teryx Forum banner

1 - 20 of 28 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
here are some pics of the snorkel
 

Attachments

·
Registered
Joined
·
1,508 Posts
the belt intake goes back under the motor? got any pics with the plastic on to see what you had to cut?
 

·
Registered
Joined
·
53 Posts
Discussion Starter #3
the only noticable plastic cutting is for the intake. the belt drive snorkel just required some clearancing of the plastic around where the seatbelt are. i will get some pics when i get the bike back together
 

·
Premium Member
Joined
·
2,102 Posts
Any jetting/bog issues at top speed?

I assume you used 2" pipe.

You should be able to go real deep now.
 

·
Registered
Joined
·
53 Posts
Discussion Starter #7
Any jetting/bog issues at top speed?

I assume you used 2" pipe.

You should be able to go real deep now.
did use 2" pipe and put 1.5" reducer on intake to get rid of off idle bog. im going to jet it when i get an exhaust system. i went waist high this past weekend and everything stayed dry
 

·
Registered
Joined
·
813 Posts
How loud is it in the cab now,im thinking about doing the belt only as the drain is so hard to get too.
 

·
Registered
Joined
·
53 Posts
Discussion Starter #9
How loud is it in the cab now,im thinking about doing the belt only as the drain is so hard to get too.
it doesnt seem to me all that much louder than stock, the headrest seems to block some of the noise
 

·
Registered
Joined
·
97 Posts
id like to see how you reduced that 4" exhaust to 2" pvc,
 

·
Registered
Joined
·
53 Posts
Discussion Starter #11

Attachments

·
Registered
Joined
·
32 Posts
Did you leave the factory belt exhaust pipe in place? If so was you able to attach it to the reducer with hose clamps?
 

·
Registered
Joined
·
53 Posts
Discussion Starter #13
Did you leave the factory belt exhaust pipe in place? If so was you able to attach it to the reducer with hose clamps?
no, the reducer took the place of the factory stuff
 

·
Registered
Joined
·
53 Posts
Discussion Starter #14
here are some pics of the plastic in place
 

Attachments

·
Registered
Joined
·
813 Posts
Man some of you guys ride the heck out of your bikes,LOL Ride'em hard and puttem up wet.
 

·
Registered
Joined
·
97 Posts
so did you use the factory rubber coupling to connect the reducer to the belt exhaust?
 

·
Registered
Joined
·
53 Posts
Discussion Starter #17
yes intake and exhaust
 

·
Registered
Joined
·
53 Posts
Discussion Starter #19
not right now, my camera operator wasnt on their toes when we went last
ive had it up to my waist sitting in the seat with no problems
 

·
Registered
Joined
·
1,508 Posts
mine died in the water yesterday for some reason.my seat was wet as i was at an angle.what all electrical connections did you grease up?
 
1 - 20 of 28 Posts
Top