Kawasaki Teryx Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
Here is the first prototype set:liebe069:
Both are 3/16 5052 Aluminum, and oversized fron the crappy OE parts. The front extends up at an angle to give it stregnth and to keep it from scooping up trail debris like the stocker. The rear also extends several inches forward into the metal tabs under the motor. I should have A-arm/CV skids available this week too.

All 6 pieces (front and rear skids + all f A-arms) should sell for around $175 plus shipping.

The last pic is the stocker.

Thanks for looking!

Chris
 

Attachments

·
Registered
Joined
·
66 Posts
looking good...lets know when all done...
 

·
Registered
Joined
·
18 Posts
Discussion Starter #4
Skids are ready to go, A-arm/CV guards are still a ways out. Here is a couple more pics... The rear will have a diff drain hole as the front, but both are a smaller 1.5 inch dimpled hole.
 

Attachments

1 - 4 of 4 Posts
Top